Tile Demolition Tips - Remove Ceramic Tile Yourself, What Should Be Paid Attention To?

2020/11/26 15:33:49

There are plenty of reasons that you may need to remove your tile wall or floor. So, when we carry out interior decoration demolition, what aspects do we need to pay attention to? In this article, we cover some tile demolition tips shared in Reddit and we discuss what should be paid attention to when removing ceramic tile yourself.

What Should We Pay Attention To When Removing Ceramic Tile

In the process of removing ceramic tiles, we must do a good job of preparation, first of all, the tools of construction work, secondly, the construction of electricity, to check whether the circuit safety of the toilet is abnormal, and so on. At the same time, the construction team should plan out the construction scheme, only by doing these work in place, can we continue the construction more safely and smoothly.
According to the actual situation of the construction site, we use some simple tools such as hammers, crowbars, shovel and tile knife to construct. When demolishing, it should be from top to bottom. It is not allowed to use the method of pushing or pulling down.
The impact drill is an important tool to knock bricks on the wall. It is different from the traditional hammers and steel chisels. It is convenient and fast to use the impact drill for construction. The bit of impact drill can be changed freely according to the construction needs.
The demolition of ceramic tile is generally from the bottom of the wall to the top, from the edge of the tile to knock inside, but also need to choose the appropriate knock brick strength according to the location of demolition.

Tips On Tile Demolition

Here are some best tips for tile demolition we’ve collected from Reddit:

Be clean. Spend time putting plastic over stuff, and basically respecting the house.
Be mindful of the baseboard and door jambs/casings. If you pry up on a tile that has one of its sides under the baseboard, it can either lift up and loosen the baseboard or, if there are little bits of broken tile on the face of it, they will get pinched between the tile and baseboard and damage the face of the trim. And you’ll likely have to get small pieces of broken tile out from under baseboard or door jamb. You can place your demo screwdriver strategically and smack it with hammer in order to pop those pieces free. It might get tempting to try to pry up a lot when those pieces are underneath the trim, but you want to avoid that and generally just take a second and think before you do anything that might damage any parts of the house.
If you are removing against a finished paint edge, like for baseboard or showers, always use a knife to cut the grout edge. If not, you will tear the paint layer. Also, if re-patching tile areas the same rule applies. Always cut the grout joints or you risk chipping adjacent tiles. When chipping out tile, always tape off the edges you don’t want to damage.

For tools for tile demolition, if you have a circular saw and a grinder you are recommended cutting relief cuts into the tile. Just set the blade depth on the circular saw to 1/2inch to get into underlayment that way you can pull it up in large squares as opposed to chipping away at it. You honestly should seriously have supervision if you haven't done this before. Also make sure you have gloves, eye protection, kneepads and a dust mask. Earplugs never hurt either.

Prev Back News List Next

Hot News